Scribing plywood (Now with more RAD)

[lastlight]

my experience with actual blades is i end up shredding the good side somehow all the time. tape or not. I'll bet my blade is old and cheap tho.

[kien]

Or you could just leave the stand as it is and just paint it.

[parkinsn]

Or just follow your track record.... Sell it and start over

[kien]

Originally Posted by parkinsn

Or just follow your track record.... Sell it and start over

[The Grizz]

Originally Posted by parkinsn

Or just follow your track record.... Sell it and start over

I think this one is a keeper with it built into the walls and all of Bretts hard work. I cant wait to see it all done, got to see the tank before the walls and finishing work and I must say its a BEAST!

[parkinsn]

Originally Posted by The Grizz

I think this one is a keeper with it built into the walls and all of Bretts hard work. I cant wait to see it all done, got to see the tank before the walls and finishing work and I must say its a BEAST!

I own a hammer, I could help him take those walls down to get it out

[lastlight]

ok I'm now at the point where on a whim I could go either way. The decision will likely be spur-of-the-moment and at 2am when I'm not fit to decide. So have your fun you MFs =)

And no a wall cannot contain my builds. The last 400 was in a wall for a very short time before I myself took a sledge to it lol. Looking back now... thank frag because I think it looks pretty hideous lol.

[The Grizz]

Well in that case........I will be standing by with my sledge hammer in hand waiting for the call for destruction

[parkinsn]

Originally Posted by lastlight

ok I'm now at the point where on a whim I could go either way. The decision will likely be spur-of-the-moment and at 2am when I'm not fit to decide. So have your fun you MFs =)

Well if your going to leave it open to debate.... Are you sure you are fit to decide this at any time of day?