Scribing plywood (Now with more RAD)

parkinsn · #1 08-30-2011, 08:50 PM

Or just follow your track record.... Sell it and start over

kien · #2 08-30-2011, 08:58 PM

Quote:

Originally Posted by parkinsn

Or just follow your track record.... Sell it and start over

The Grizz · #3 08-30-2011, 09:01 PM

Quote:

Originally Posted by parkinsn

Or just follow your track record.... Sell it and start over

I think this one is a keeper with it built into the walls and all of Bretts hard work. I cant wait to see it all done, got to see the tank before the walls and finishing work and I must say its a BEAST!

parkinsn · #4 08-30-2011, 09:08 PM

Quote:

Originally Posted by The Grizz

I think this one is a keeper with it built into the walls and all of Bretts hard work. I cant wait to see it all done, got to see the tank before the walls and finishing work and I must say its a BEAST!

I own a hammer, I could help him take those walls down to get it out

lastlight · #5 08-30-2011, 09:17 PM

ok I'm now at the point where on a whim I could go either way. The decision will likely be spur-of-the-moment and at 2am when I'm not fit to decide. So have your fun you MFs =)

And no a wall cannot contain my builds. The last 400 was in a wall for a very short time before I myself took a sledge to it lol. Looking back now... thank frag because I think it looks pretty hideous lol.

The Grizz · #6 08-30-2011, 09:20 PM

Well in that case........I will be standing by with my sledge hammer in hand waiting for the call for destruction

parkinsn · #7 08-30-2011, 09:23 PM

Quote:

Originally Posted by lastlight

ok I'm now at the point where on a whim I could go either way. The decision will likely be spur-of-the-moment and at 2am when I'm not fit to decide. So have your fun you MFs =)

Well if your going to leave it open to debate.... Are you sure you are fit to decide this at any time of day?

lastlight · #8 08-30-2011, 11:54 PM

You must BELIEVE in the power of the SCRIBE!!!

In summary:

Going with the grain is FULL-ON-BAWLS. Removes in one strip with a much sharper edge. Heck it even sliced easier and took half the time =)

And plywood-on-end isn't even that bad for a really quick attempt.

GAME ON.

parkinsn · #9 08-31-2011, 12:12 AM

Isn't it Balls to the wall or stand in this case? YOU might be full on balls....

On topic, looks pretty good. I like the idea. How are you going to finish the "cuts" paint/stain or just leave them rough?