|
|
|
|
|
#1
05-15-2008, 05:18 PM
|
||||
|
||||
I have a reactor for my ultralith but if I had a smaller tank and was going to run a phosban reactor I would put a line running into the reactor from my main return with a gate valve.. Make sure other hoses are clamped onto the reactor for pressure and open the gate valve slightly to force high powered water into the phosban.. This should stir things up with no need to remove and shake. Just a thought?? I dont know.. I am considering modifying my reactor so my aquatronica mixes the reactor daily with pressurized water?? I want everything automatic...
__________________
Gerad White Rock 
|
|
#2
05-15-2008, 05:40 PM
|
|||||
|
|||||
|
Air for a minute while shaking shouldn't case a problem. The warnings on the zeovit literature are to make sure the stones are not dry while the pump is off if you are running the reactor 3 hours on, 3 hours off.
I'm using a three fishes phosban reactor for zeovit. I have a shutoff valve just before the reactor so don't need to remove the hoses when I shake it. Just turn off the valve, pick up the reactor and shake, hang it back on my tank, and turn teh valve back on. Once teh flow is turned back on any air bubbles get pumped out.
|
Hybrid Mode
