Milad's 72in LED build

[Milad]

Originally Posted by StirCrazy

interesting. since you built the board from scratch did youmake it so you could just plug it into 120v or do you need to power it with 12v?

Steve

It needs 12v. Most people have a 12v around the house. We also gave the flexibility to them to use different current for different setups. So if you are just doing drivers, you need a very low current power supply (500mA). If you are doing LEDs directly then you can get a 5A power supply.

I also got the update on the new LEDs. Prototypes are in route to Vancouver as we speak. I should have them early next week if not tomorrow. I have a PAR meter in route also. Im going to run some numbers comparing a CREE Setup vs the new LEDs (i might do some 150w MH just to get an idea.

If everything looks good they will go into production and I should be getting them sooner than later.