Building tank - 2 questions

[GoFish]

Just the guy I was hoping to hear from thank you Denny
Without spacers how do you know if "proper spacing" is there. (Or what is proper spacing). If using bar clamps I don't wanna squish all of the silicone out of the joint....Or I could use use Duct Tape but I have a feeling thats not something Concept would do

[reefwars]

Tape is fine it'd not a large tank and it's not holding water so clamps probably are overkill

A 1/16+ spacing is fine , main thing is glass doesn't touch glass very important ok , measure your panels and you'll be able to figure out the spacing allowed when it was cut

For home made spacer cut a small 1x8" x 1x8" piece of vinyl hosing or similar make sure it's flat is all one on top one on bottom

[reefwars]

Not duct tape preferably construction grade masking tape or any similar tape will do , duct tape leaves a horrible track mark and need methal hydrate to get it off lot of work

[reefwars]

Haha I don't mind if I was in a jam I'd hope an aquarium guy would step up and help me karma

[canadianbudz604]

Can't wait to see pics of this thing

[WarDog]

Don't mind me... I'm just here to listen to Denny reveal all the trade secrets!

[GoFish]

Originally Posted by WarDog

Don't mind me... I'm just here to listen to Denny reveal all the trade secrets!

Lol

Originally Posted by reefwars

Tape is fine it'd not a large tank and it's not holding water so clamps probably are overkill

A 1/16+ spacing is fine , main thing is glass doesn't touch glass very important ok , measure your panels and you'll be able to figure out the spacing allowed when it was cut

For home made spacer cut a small 1x8" x 1x8" piece of vinyl hosing or similar make sure it's flat is all one on top one on bottom

Funny before I left the house I was cutting 1/8" rubber cubes from an RO membrane seal, I'll continue on

Thanks again for the advice resident "aquarium guy"

It didn't seem like a tank build until It was all in pieces. After 2+ hours of cleaning silicone it's NOT something Id wanna do over

Originally Posted by canadianbudz604

Can't wait to see pics of this thing

Lost my camera, I'll try

[reefwars]

Originally Posted by Vancity

Lol



Funny before I left the house I was cutting 1/8" rubber cubes from an RO membrane seal, I'll continue on

Thanks again for the advice resident "aquarium guy"

It didn't seem like a tank build until It was all in pieces. After 2+ hours of cleaning silicone it's NOT something Id wanna do over



Lost my camera, I'll try

People offer us used tanks all the time their often surprised when we say we don't take them lol the work involved tearing apart cleaning modding and rebuilding is brutal lol