Wavy Sea help

tim the toolman · #1 01-31-2013, 04:51 PM

Use the larger oring and take a standard drill mounted sanding drum and slightly sold the inside edges of the piece you ar trying to slip onto the oring. Had the same problem modding an old hob overflow and it worked great just go slowly so ou don't take to much material

christyf5 · #2 01-31-2013, 05:26 PM

Weird, I'm pretty sure I just crammed a 1" elbow on mine. I'll have to have a closer look tonight as I was thinking of doing the same thing when I first got it, then decided as it was at the front of the tank, I didn't want it being more obtrusive than it already is.

Werbo · #3 01-31-2013, 05:39 PM

My used unit came with a stock black elbow but it is slightly smaller than 1 inch and is a speciality fitting for the outlet coming out of the wavy sea.

christyf5 · #4 01-31-2013, 05:42 PM

Quote:

Originally Posted by Tyler Werbowski

My used unit came with a stock black elbow but it is slightly smaller than 1 inch and is a speciality fitting for the outlet coming out of the wavy sea.

Hmm, mine is white. I'm pretty sure it is "aftermarket" but I'll have a closer look tonight when I get home and see what I did. May have used some teflon tape or something but I'm pretty sure it wedged on there fine. Now I want to go home and have a look

Delphinus · #5 01-31-2013, 06:12 PM

I wrapped a ridiculous amount of teflon tape around mine to make a snug fit.

Rather annoying that it's not a standard snug fit .. maybe it's a metric thing. Metric fittings aren't real easy to source, though.

Good luck....

The Codfather · #6 01-31-2013, 06:49 PM

Quote:

Originally Posted by Delphinus

I wrapped a ridiculous amount of teflon tape around mine to make a snug fit.

Rather annoying that it's not a standard snug fit .. maybe it's a metric thing. Metric fittings aren't real easy to source, though.

Good luck....

You bet.
Its metric.
I can see what I have at home, how much do you need?

Reefer Rob · #7 01-31-2013, 07:00 PM

You can actually shrink PVC down by heating it in an oven until its soft, I think 200 F would do it, then GENTLY tighten a hose clamp around it while its in place. Remove the hose clamp after it cools, and if you didn't tighten the hose clamp too much it will be a tight slide fit.