|
|
|
|
|
#1
01-19-2013, 05:23 AM
|
|||||
|
|||||
Most of my wiring will be going through access holes on the right side of the cabinet, however on the left side I mounted a pair of water proof junction boxes on either side and wired outlets on the sump side and switches on the dry side. I did this because I always seem to have to cut power to my return pump in a hurry somehow. Unplugging it might be hazardous with wet hands, and going through the controller just takes too long, so this is my solution.
 Also I have everything transferred over to the new tank now, and in my haste to transfer everything, I ended up with quite the mess! 
__________________
|
|
#2
01-19-2013, 05:26 AM
|
|||||
|
|||||
|
... And a few hours later.
 It's not perfect. I could do with a more eloquent design for the EB8 rack, but it was a quick fix for not realizing the bar would fit in the stand, but the power cord would not. Maybe sometime down the road I'll rebuild this section and make it a little more professional looking.
__________________
|
Hybrid Mode
