Attaching Heatsinks to Hoods

[gregzz4]

I've never built something like this, so Snaz is your better go-to for help

If it were me, I'd go with the removable brackets
Safer, and easy to remove for maintenance/repairs

I see 4 corners of your acrylic splash guard look like they have screws - or are they just some kind of pressed thingys ?
Could you remove the guard, drill the sink and mount it to those holes ?

If you were a bit closer I'd come look

[Enigma]

@Greg The sink is too small for that. But, I might be able to mount brackets on the heatsink to screw into those holes. Bar stock would work. Attach the bar stock to the corners of the heat sink, drill holes in the bar stock, and put the splash guard screws through the splash guard and the holes in the bar stock.

I think you coming over to look would make us an "unofficial team" in the nano contest. No teams!

[gregzz4]

Originally Posted by Enigma

I think you coming over to look would make us an "unofficial team" in the nano contest. No teams!

Didn't realise you were entering this one
Good thing I don't live down the street ....

I think you're on the right track with some non-permanent mounting
Keep brainstorming .. you'll come up with something

[waynemah]

I did a nano a while back

Once you get all the guts out of the unit, there will be remaining mounting holes in the plastic. From there just drill holes in the heatsync that lineup, screw it down and your done

[lpsreefer]

Four washers and bolts/nuts showing on the top sides doesn't stand out. I was super surprised.