Where to get Chiller fixed??

[gregzz4]

Originally Posted by LeanneP

The flow is 350 gph and I have the chiller set at 78 degrees and it should kick in at 2 degrees higher at 80 degrees

Ok, so less than 350 gph and I assume you mean your hysterisis is 2 degrees
We'll work on this setting later, after we get it running right

Originally Posted by LeanneP

it still didn't seem to give me the correct temp

You may still need to set the Pd, or a similar code
If you hold the set button for, maybe, ten seconds or so, it will give you access to the initial temp and hysterisis settings
Mine reads Pd ( or ca, I had 2 chillers with different codes ) for temp calibration, and d for the hysterisis ( temp to run on and off ), not to be confused with the actual temp control setting

So,
Pd ( ca ) is temp calibration to your water
d is the hysterisis ( how much cooling variance you want )
xx degrees is your set temp

What readout do you get when you hold the set button for 10 or seconds ?
Mine starts with Pd, and if I press the set again, I get the d