Arc fault circuit interupter

[kole]

Flood would not reach the height of the outlet. Spraying water is another possibility. I have the power bars high up and make drip loops. I had the front pane of glass of a 125 gallon break several years ago, when I found it water was spraying out through the crack. Had it been the back panel the outlets would have been very wet. Didn't think of nuisance outages I'm going to read up on them some more thanks.

[troni]

I'm an electrician, and gfci detects the difference in current coming in on the hot wire and back on the neutral and they must be the same or it trips. That's why they're usednear sinks and stuff. And if you want the extra precaution raise your plugs to a satifying height. Or hardwire them. Use your imagination. Install a box in the wall cavity that has a door which will allow enough room for just your cords to passby and have some plugs inside the box.

[outacontrol]

Originally Posted by troni

I'm an electrician, and gfci detects the difference in current coming in on the hot wire and back on the neutral and they must be the same or it trips. That's why they're usednear sinks and stuff. And if you want the extra precaution raise your plugs to a satifying height. Or hardwire them. Use your imagination. Install a box in the wall cavity that has a door which will allow enough room for just your cords to passby and have some plugs inside the box.

Well I am also an electrician and it is against code to install receptacles in cabinets or cupboards, so that is not very good advice! It is also against code to move your receptacles without a permit, so for most reefers that is not great advice either.
Installing AFCI is probably a good idea, but be careful not to put everything on one control device. You don't want your whole tank turning off due a tripped breaker or receptacle. GFCI is a must though!
Buy some good quality powerbars, plug them into GFCI receptacles and always use a drip loop in all your cords.

[troni]

Originally Posted by outacontrol

Well I am also an electrician and it is against code to install receptacles in cabinets or cupboards, so that is not very good advice! It is also against code to move your receptacles without a permit, so for most reefers that is not great advice either.
Installing AFCI is probably a good idea, but be careful not to put everything on one control device. You don't want your whole tank turning off due a tripped breaker or receptacle. GFCI is a must though!
Buy some good quality powerbars, plug them into GFCI receptacles and always use a drip loop in all your cords.

Ya your right slipped my mind about cabinet. My excuse is I'm commercial. And no permit need to raise a plug can't think of the rule but I'm pretty sure no permit to move a few plugs. Well not in alberta.

[outacontrol]

Originally Posted by troni

Ya your right slipped my mind about cabinet. My excuse is I'm commercial. And no permit need to raise a plug can't think of the rule but I'm pretty sure no permit to move a few plugs. Well not in alberta.

Not trying to be a jerk here, but wrong again. A permit is required for any change to any electrical system, moving a receptacle is definately a change.
Permits are not required for maintance such as replacement of a receptacle.

Since you brought of the rules, CEC rule 2-004 states; Electrical contractors or others responsible for carrying out the work shall obtain a permit from the inspection department before commencing work with respect to installation, alteration, repair, or extension of any electrical equipment.

This applies to everywhere in Canada as it is the Canadian Electrical Code. It applies to everyone and applies to any changes to any electrical system.

[Nate]

Bazinga!

[troni]

Must of been years since you've been on tools huh? Cause your talking like a office guy. Nobody is going to get a permit to move a plug.

Yes its the canadian electrical code but its a suggested code. Every province has its own legislatio