![]() |
|
|
|
#1
|
|||||
|
|||||
|
Still trying to figure out how to put humpty dumpty frogspawn back together again!!
__________________
Brad |
|
#2
|
|||||
|
|||||
|
Yeah I don't think that is going to happen, I've found using epoxy and some of those frag plugs as props can help though.
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free. |
|
#3
|
|||||
|
|||||
|
Is it a branching frogspawn? If so what about zip-ties near the bottom and rubble in between branches with more zip-ties nearer to the top to make it fan out?
|
|
#4
|
|||||
|
|||||
|
Ya, I think I can tie it back together, maybe a bit of gel clue. Looks like 3 clean breaks through the bottom of the branches. I have a 3 pound "frag" mounted on a magnet and it dropped right into the froggy
__________________
Brad |
|
#5
|
||||
|
||||
|
I fixed a trumpet coral once by rolling out some putty and wrapping it.. Kinda made a cast and it held ok.
|
|
#6
|
|||||
|
|||||
|
Quote:
Otherwise its going off to the lfs - I've got 2! And yes - frag swap in April is good - I might even have some stuff to bring this time........maybe ![]() |
|
#7
|
|||||
|
|||||
|
Quote:
![]() I may end up needing some LPS though for my daughter's tank, let's see what you've got in April!
__________________
Brad |