|
|
|
|
|
#1
01-13-2012, 04:40 AM
|
||||
|
||||
Actually, I wasn't thinking vertical...I don't think I have room for that even with 9' ceilings. I was planning on bolting it to the joists horizontally. Why would you have torn out the ceiling...were you only using plugs or was it attached to solid wood?
__________________
Mark...  290g Peninsula Display, 425g total volume. Setup Jan 2013. 
|
|
#2
01-13-2012, 04:44 AM
|
|||||
|
|||||
|
I had that metal shoe on the end that was guided along the wooden channels. I was always scared it would snag on the wood like it did before I refined it. Doing so would rip the enclosure apart. Also over time the wire may have frayed on the metal bearings.
Fun project but not the safest way to suspend an expensive light lol. Made much worse for the nerves when you can't actually see the mechanism anymore! Last edited by lastlight; 01-13-2012 at 05:29 AM.
|
|
#5
01-17-2012, 02:48 AM
|
|||||
|
|||||
|
You mean...like mine?
  
__________________
400 gal reef. Established April, 2007. 3 Sequence Dart, RM12-4 skimmer, 2 x OM4Ways, Yellow Tang, Maroon Clown (pair), Blonde Naso Tang, Vlamingi Tang, Foxface Rabbit, Unicorn Tang, 2 Pakistani Butterflies and a few coral gobies My Tank: http://www.canreef.com/vbulletin/showthread.php?t=28436
|
|
#6
01-17-2012, 03:02 AM
|
||||
|
||||
|
No...not like yours....I would need another degree to make something like that. Plus a lot more patience than I have left.
 More like what is documented here: http://www.kenargo.com/lightLifter/index.php
__________________
Mark... 290g Peninsula Display, 425g total volume. Setup Jan 2013.
|
|
#7
01-17-2012, 03:06 AM
|
||||
|
||||
|
Although now that I think about it...I may be over-thinking things and maybe I just need to go with one of these and a couple of pulley's.
http://www.northerntool.com/shop/too...5356_200395356
__________________
Mark... 290g Peninsula Display, 425g total volume. Setup Jan 2013.
|
Hybrid Mode
