![]() |
|
#1
|
|||||
|
|||||
![]() I would either go to Home Depot and buy some window screen material and put a few sheets over the tank to "shade" the light a bit. Then every week take a sheet off so that the light is getting more intense by the week.
Another option is to run your lights 1/2 hour on, one hour off, 1/2 hour on, one hour off and then gradually "meld" the photoperiod into one long photoperiod over the course of a few weeks. (This is how I did it when switching from 150 watt halides to 250 watts) It just takes more fooling around with the timer. I was too lazy to go buy screen material and rig it so that it would "sit" over the tank and under the lights. Hope this helps. Last edited by Dez; 04-22-2010 at 03:55 AM. |
#2
|
|||||
|
|||||
![]() +1 Cut your hours back and increase slowly.
Watch for corals going lighter in color move them to the side or down a bit, and raise your lights if you can.
__________________
150 Gal system 3'x3' 400W M/H, Bekett skimmer, Dart return,1/4 HP Chiller 180 Gal Drop tank, LED lights, Bubble master 250 skimmer,Hammerhead on a closed loop, Speed wave return. |
#3
|
||||
|
||||
![]() Thanks for the replies. I think I will try starting at 4hrs/day and slowly increasing from there. I hope the heat won't be too much of an issue otherwise I may just sell this and go for a 48" T5HO light fixture. I do like the shimmer though
![]()
__________________
Jennifer |
#4
|
|||||
|
|||||
![]() 4 hours at once? That might be a bit much, keep an eye on your corals for bleaching.
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free. |
#5
|
||||
|
||||
![]() I bumped it back a bit to be safe. Does one hour on, one hour off, one on sound okay? I have a torch coral, open brain, gsp, xenia, toad stool, and a BTA. They are all on or near the sand bed at the moment.
__________________
Jennifer |
#6
|
|||||
|
|||||
![]() I would stick to 1/2 hour on 1 hour off just to be safe because your corals really didn't have too much light before compared to your new light/new bulbs. I know it's a pain, but I'd like to error more on the safe side.
|
#7
|
|||||
|
|||||
![]() I was told that turning mh off and on frequently like that is hard on the bulbs as well as the ballasts. Someone correct me if i'm wrong please. I would have them turn on for just a couple of hours where you know it will be the middle of your lighting period, increase the time by 20 more minutes each day until you reach your actual time they will be on every day. 10 minutes earlier and 10 minutes later each day. Most people on run mh's 6-8 hours per day. Also think that it will stress your fish out if the lights keep going off and on. Everyday when my mh's turn on there seems to be a burst of energy with the fish for a couple of seconds (freak out). And yes heat will be a bit of a concern during summer months.
|