For those not using a dosing pump, but otherwise automated dosing thingamajig...

globaldesigns · #1 11-19-2009, 03:33 AM

Quote:

Originally Posted by Delphinus

I run 4 aqualifter pumps so I can dose Ca & Alk into two separate tanks. Two timers set to run for 1 minute intervals on 1.5 hour intervals. Each dripline ends with an irrigation needle valve for drip control. Think I spent $15 each for the aqualifters. Everything else I already had.

The driprate is way more steady than I ever thought it would be. It's working out well, in fact, I pretty much have the needlewheel valves open all the way. I haven't tested yet this week to see where my Ca is at but I was debating switching the 1 minute durations to 2 minutes.

Hey, would you ever allow someone like myself to come see the setup. I too have been thinking about this, but am too scared to screw things up. Would love someone to show me the ropes.

Delphinus · #2 11-19-2009, 03:39 AM

Sure, there's not much to it, but you're totally welcome to check it out. Please promise not to laugh at the state of my basement.

Shoot me a PM sometime, I'm down in Evergreen. I'll try to take a picture of it maybe but I have to find my camera's battery charger first.

Oceanic · #3 11-19-2009, 05:34 PM

I have tried all kinds of dosers including the Aqualifter pump, the best thing I have found is one of these recommissioned hospital IV peristaltic devices.

I found mine on Ebay but they are worth the money new. I use the device to feed my calcium reactor partnered with my reef controller controlling the PH inside the reactor. I do not have to fiddle with bubble rates, drip rates or anything.

If my ALK levels are off I just increase the ML per Hour or decrease depending on my test results. Easy as PIE!! Next to my controller this is the best purchase I made for my system in regards to water quality.

lastlight · #4 11-19-2009, 06:06 PM

Any idea what brand and roughly how much ? You need to buy one for each solution of course too.

Oceanic · #5 11-19-2009, 06:59 PM

Quote:

Originally Posted by lastlight

Any idea what brand and roughly how much ? You need to buy one for each solution of course too.

These are available from www.innovativeaquatics.com. You do not have to buy two, you just simply run the two channel tubing that is available, it does equal doses of two separate fluid simultaneously. They are well worth the money.

Ian

Two channel tubing.

lastlight · #6 11-19-2009, 08:44 PM

I thought ca and alk are used in different amounts. Do you compensate for this by altering the concentrations of each solution?

Delphinus · #7 11-19-2009, 08:57 PM

For the most part in a prebalanced tank, you will add both at fairly close the same rate. You could always do a manual adjustment say once a week if there was drift in one of the parameters.

Having said that, I would prefer being able to add both independent of one another.

I know with the Masterflex peristaltic pumps (lab grade, very expensive, although the occasional good deal comes up on ebay .. also LittleSilverMax had at one point, one for sale, if anyone wanted one of these they should send him a PM) can have interchangeable heads to allow for different flowrates which basically involve different sized tubes or different diameters of the rollers). But the speed at which the rollers turn would be the same for each head so it's still not AS independently adjustable from each other that two seperate feed pumps would be.

Oceanic · #8 11-19-2009, 09:06 PM

Quote:

Originally Posted by lastlight

I thought ca and alk are used in different amounts. Do you compensate for this by altering the concentrations of each solution?

Yes, as stated above, once the levels are adjusted manually they are supposed be dosed at equal amounts. The Randy Holmes two part mixture for calcium and Alk is calculated to replace the elements at the same levels they are depleted. I would not run two dosing pumps; however, you would want to make sure each tube that drips the elements are in a separate part of the system or sump.

Ian