|
|
|
|
|
#1
12-16-2008, 06:58 AM
|
|||||
|
|||||
I have the Precision Marine and it is simple to operate set your bubble rate (approx one per sec.) and then adjust your effluent till it runs about 6.5-7ph, it's not a steady stream just a fast drip. My calcium level runs between 420-450 and Alk at 8-10dkh with no other additives and I recharge it about every four months. (I am also using the pinpoint ph controller to automatically turn the co2 on and off as needed)
|
|
#2
12-16-2008, 07:06 AM
|
|||||
|
|||||
|
my biggest recommendation is to get one that you can have a ph probe inserted into and monitor your ph. it is a pain in the butt if you have to test your effluent all the time for the ph within the reactor
|
|
#3
12-16-2008, 07:21 AM
|
|||||
|
|||||
|
__________________
28g Nano Cube drilled with 13g sump in stock stand. Vertex IN80 Skimmer, Phosban 150 Reactor, Apex Controller, DIY LED with stock hood, dimmable Established March 2006
|
|
#4
12-16-2008, 01:47 PM
|
|||||
|
|||||
|
__________________
Doug
|
Hybrid Mode
