Phosban Reactor

[fkshiu]

[quote=Van-rookie;282303]

Originally Posted by fkshiu

The reactor is simply a chamber to put media (whatever you want: carbon, GFO, etc) into. You then attach a small pump to the reactor which pushes water through. It's more effective than just a filter bag because water passes through and all around the media evenly.
QUOTE]

so the fuction is similar as fluval filter ?

Sorta, but the key difference is that the reactor operates at a much slower flow rate allowing the media to freely percolate which makes the media much more effective. In a canister filter like a fluval you have to use a media bag which results in a lot of bypass and the flow rate is also too high to optimize contact time.

[Van-rookie]

i see.
would it be ok to take out carbon from the bag and put them directly on the compartment ?

[michika]

Originally Posted by Van-rookie

i see.
would it be ok to take out carbon from the bag and put them directly on the compartment ?

Yes, you can, just make sure to keep the floss circle tops above and below your carbon.

[Johnny Reefer]

Originally Posted by Van-rookie

i see.
would it be ok to take out carbon from the bag and put them directly on the compartment ?

I just asked this very same question in another thread I started a few days ago. I got one response saying they had done it. I'm doing maintenance to my reef tomorrow. Will then be running my Fluval 405 with 3 of the 4 baskets full of just carbon. No bags. At the top of the third basket I will use cut to size HBH carbon pads to prevent carbon bits reaching the impeller. The 4th (top) basket will be empty. This will probably allow me to increase my carbon use by 1.5x. I've been told you can't use too much carbon so I'm increasing the amount I use in an attempt to win some ongoing pest battles. But I digress and am getting off topic here.

Cheers,