Profilux II plus aquarium controller

[Draven]

I know that in order to run Two Tunzes on one port, you need a Y adapter. Is the Y adapter the same that would be needed for LED lighting? Course, I am not even positive if you can run the LED lighting on the Y adapter to begin with so that would be helpful too. I havent been able to find much info on any of the vendor sites about this.

[niloc16]

i'm pretty sure it is the same y adapter. when doing so, both led lighting plugged into that adapter will be controlled the same. meaning that they will both dim the same amount at the same time, they will not be able to be controlled individually.

[big blue]

The standard Y-Adapter doubles the input L1/L2 to two outputs of each L1/L2. So the channels will behave as parallel wired.

The cross over adapter has one input L1/L2, one output L1/L2 and one L2/L1. If it is not available you can rewiring yourself if you can solder and do not have two left hands.

There are some pictures of it in a german forum but I am not shure if you can understand it, but at least you will see the picture.
http://www.aqua-it.de/phpBB2/viewtopic.php?p=2087#2087

[Draven]

Big Blue,

I checked out the site, sadly bablefish's translation was a bit poor. I could understand some of it, but then some just didnt make any sense to me at all. So the YL2-2,5 adapter is which Y adapter? This was talked about in the post but thats where some of the poor translation came into play. I am curious if this is the crossover adapter or if this is just the one that replicates the port giving you two of the same.

[Matthias Gross]

I'll try to clarify it:
we have the splitters YL2-1 and YL2-2.5, one is 1m long, the other is 2.5m
They have the same function: Just double the ports, no crossover
The splitters are suitable for lighting and pump control
If you want to connect two controllable pumps on one port (eg L1L2) you need: 1 splitter, 1 cable ProfiLux<->Tunze1 (the pump connected over this cable will react on L1) and 1 cable Profilux<->Tunze2 (reacts on L2)

[monitors_direct]

Thanks for the explanation matthias we have the same confusions in the UK.

[Draven]

That explains it perfectly. Thank you. Do you guys sell a Y crossover adapter or is this something that we would have to buy locally at one of our electronic stores? This would be for stuff other than the Tunze's such as two LED lights, or a light and the fans, etc.