|
|
|
#3
05-09-2005, 12:21 AM
|
|||||
|
|||||
$12 float switch from hydroponics store
$5 3 gallon rubbermaid container $?? John Guest fitting and tubing (stole from the "taste filter" part of my RODI that I wasn't using). You can get the tubing from Home Depot in the water filter department, and I don't know where you can get the JG fittings from, I just used mine because it was handy. Drill hole in rubbermaid about 1 inch from bottom, screw in JG fitting and silicone. Attach tubing. Install float switch (Jack made me a skookum float switch holder, its L shaped and is siliconed onto the sump, the float switch is attached to that). Hook up free end of tubing to float switch. Sorry I don't have any pics. I can get some later on though. Its a pretty simple setup. Perhaps too simple. This is coming from a DIY challenged person  Oh and I don't supplement anything Christy 
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free. 
|
Threaded Mode
