Chiller help... wont chill

[nerdz]

My pacific Coast 1/10Hp chiller no longer cools...

I don't require it because my house is cool, so I tested it before posting it for sale... Only to discover a problem.

The thermostat functions and the compressor kicks on at set point. I assume coolant leaked out? Actually, I have no idea ha, ha!

So, is there any hope?

Thanks in advance for any advice.

Cheers

[Aquattro]

It's possible that it needs a recharge, but if you've got a leak in it, it might cost more to fix than you can sell it for.

[Magickiwi]

Stupid question but you are using a pump to circulate the water through the chiller? I don't know what your knowledge level is so I don't mean to be insulting.

I'd check your vents etc. and make sure they're free of dust and crud. Was it in a location that got a lot of foot traffic?

[nerdz]

Originally Posted by Aquattro

It's possible that it needs a recharge, but if you've got a leak in it, it might cost more to fix than you can sell it for.

Yes, this is probably the case...

Originally Posted by Magickiwi

Stupid question but you are using a pump to circulate the water through the chiller? I don't know what your knowledge level is so I don't mean to be insulting.

I'd check your vents etc. and make sure they're free of dust and crud. Was it in a location that got a lot of foot traffic?

Yes, pump circulated water through it, vents and pre-filters are clean.

Just didn't know if anyone had any ideas or knowledge of a cost effective recharge option.

Cheap consumer goods like these probably have pinched and soldiered shut piping rather then a valve to recharge refrigerant... I haven't taken it apart yet.

[Magickiwi]

Originally Posted by nerdz

Yes, this is probably the case...




Yes, pump circulated water through it, vents and pre-filters are clean.

Just didn't know if anyone had any ideas or knowledge of a cost effective recharge option.

Cheap consumer goods like these probably have pinched and soldiered shut piping rather then a valve to recharge refrigerant... I haven't taken it apart yet.

I don't think the CSA would approve refrigeration equipment with no valve to drain, add refrigerant. I am not 100% positive but I am pretty sure it's law that refrigeration equipment must have a way to release (and subsequently refill) refrigerant without allowing it to drain to the atmosphere.

Any experts out there that can provide input?

[tang daddy]

What kind of chiller is this, the older models back then used r80 gas, even if you wanted to refill the newer gas they use is different gas these days...

If you're sure it's a leaker best to scrap it....

[StirCrazy]

Originally Posted by Magickiwi

I don't think the CSA would approve refrigeration equipment with no valve to drain, add refrigerant. I am not 100% positive but I am pretty sure it's law that refrigeration equipment must have a way to release (and subsequently refill) refrigerant without allowing it to drain to the atmosphere.

Any experts out there that can provide input?

yup they would, lots of sealed systems out there including the fridge in your house. different ways to service them, puncture valves that get soldered in place. when they are filled at the factory they just inject it into the copper pipe pigtails then crimp the ends when they are full, and solder then for the final seal. I know if I got stuff in that was low or empty I would just solder service valves on them.

Steve