|
|
|
#1
10-01-2012, 02:57 AM
|
||||
|
||||
SWC 160 Skimmer Issues
I bought a new pump for my SWC 160 (not the cone one) a few months ago. When I purchased the new pump, the amount of water it pushes through seems to be a lot more so I had to put in a stand or it would flood the Skimmer cup.
I cleaned it out recently and now it floods the skimmer cup regardless. I can't seem to slow down the flow. Any ideas on how to fix this? Could I have put it back together wrong or there is a seal missing? Thanks, Patrick 
|
|
#2
10-01-2012, 05:33 AM
|
||||
|
||||
|
My SWC skimmer is controlled by a grey vertical tube that opens/closes the flow rate. That's how I control the water level in the skimmer/skimmer cup.
__________________
If you see it, can take care of it, better get it or put it on hold. Otherwise, it'll be gone & you'll regret it!
|
Linear Mode
