|
|
|
#1
11-09-2003, 05:47 PM
|
|||||
|
|||||
pH probe maintenance
My pH probe is covered in coraline bits, tubeworms, and other stuff. I brushed most of the stuff off but I don't want to scrape the glass probe itself for fear of damaging it.
Is it a bad idea to let it soak in vinegar for a few hours? I assume I'd need to recalibrate afterwards. What do others do to keep their probes shiney clean?
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee! 
|
|
#2
11-20-2003, 09:14 PM
|
|||||
|
|||||
|
According to Randy over at RC ... soak in mild solution of 1 part vinegar to 10 parts water overnight and then recalibrate.
Cheers
__________________
Steve “The most important decision you make is to be in a good mood.” ― Voltaire
|
|
#3
11-20-2003, 09:26 PM
|
|||||
|
|||||
|
Soaked in vinegar and then RO then recalibrated like .. almost two weeks ago but thanks
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee!
|
Linear Mode
