|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Display Modes |
#1
|
|||||
|
|||||
Anyone have a router??
I don't have access to a router anymore, and I need to carve out some teeth for overflows in some acrylic. Anyone have a router I could borrow, or who would be willing to do it for a case of beer or coral frag or ??? There is only about 12" of teeth I need done.
|
#2
|
|||||
|
|||||
You can use a table saw thats what I use just mark and keep moving your fence over. You won't end up with the round hole on the bottom but square works just as well.
__________________
150 Gal system 3'x3' 400W M/H, Bekett skimmer, Dart return,1/4 HP Chiller 180 Gal Drop tank, LED lights, Bubble master 250 skimmer,Hammerhead on a closed loop, Speed wave return. |
#3
|
|||||
|
|||||
I don't have a table saw either. But thanks for the idea!
|
#4
|
||||
|
||||
Send me down the piece of acrylic, we can do the teeth for you.
All the best. Wendell Ocean Aquatics. |
#5
|
|||||
|
|||||
Hey, that would be great, and thanks for the offer! But...the acrylic only cost me $10, and shipping would prob be $20 by the time I got it back. I may be heading down to the lower mainland in the next month, and if my procrastinating butt hasn't set the tank up by then, I will bring the acrylic with me.
|
#6
|
|||||
|
|||||
Anyone? I'll drive anywhere from Vernon to Penticton...
|
#7
|
|||||
|
|||||
I got one here, w/ a acryllic bit in it
|
#8
|
|||||
|
|||||
Check your PMs.
|
Thread Tools | |
Display Modes | |
|
|