Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Reef

Reply
 
Thread Tools Display Modes
  #1  
Old 04-30-2007, 07:29 PM
csnow csnow is offline
Junior Member
 
Join Date: Apr 2007
Location: Edmonton
Posts: 11
csnow is on a distinguished road
Default Is tank on hardwood floors a bad idea?

I am moving into a new house with hardwood floors. I have a 55gallon tank that I want to setup as a reef tank (converting from freshwater).

Is there anyone that can share some stories or insight on placing tanks on hardwood floors? Will the weight cause dents/damage to the floor?

If it will cause damage, is there anyway to prevent this?

Thanks!
Reply With Quote
  #2  
Old 04-30-2007, 07:36 PM
Dragonsteeth Dragonsteeth is offline
Junior Member
 
Join Date: Mar 2007
Location: North Vancouver, BC
Posts: 21
Dragonsteeth is on a distinguished road
Default

I have my 33g on hwf with the load spread on 1.5" sp per leg. I have felt on the footings and i much prefer this to being on carpet. I can easily slide my stand around (gently) so that i can get behind etc. My floors are Oak. Just spread the load as much as possible.
Reply With Quote
  #3  
Old 04-30-2007, 09:07 PM
bassman bassman is offline
Member
 
Join Date: Aug 2006
Location: Quesnel, BC
Posts: 313
bassman is on a distinguished road
Default

I am also moving to a house with hardwood floors and I am planning on placing my 55 gal and stand on a thick rubber mat. This will protect the wood floors from denting, scratching and water damage. If water were to get under your stand and into the hardwood it could easily rot the wood and cause some warping. Better safe then sorry.
__________________




230 mixed reef / 230 gal sump/fuge
Reply With Quote
  #4  
Old 04-30-2007, 09:09 PM
dr_chee dr_chee is offline
Junior Member
 
Join Date: Apr 2007
Location: Calgary
Posts: 4
dr_chee is on a distinguished road
Default

I also have a rubber mat that I placed under the tank with a lip that curves upwards. So far so good.
Reply With Quote
  #5  
Old 04-30-2007, 09:14 PM
Murminator's Avatar
Murminator Murminator is offline
Member
 
Join Date: Oct 2004
Location: Edmonton, AB Northeast
Posts: 1,263
Murminator is on a distinguished road
Send a message via MSN to Murminator
Default

I have my 90 on HW it is fine until my skimmer overflowed yesterday and a few of the boards around the tank are curled
__________________
Murray


I reserve the right to hijack any thread I want to!!

My carbon footprint is bigger than your carbon footprint !!!!
Reply With Quote
  #6  
Old 04-30-2007, 09:57 PM
04scoobysti's Avatar
04scoobysti 04scoobysti is offline
Member
 
Join Date: Mar 2007
Location: Edmonton
Posts: 226
04scoobysti is on a distinguished road
Default

Yea, but if you put that rubber mat under the tank and you spill any water around the tank it will be stuck between the rubber and the hardwood till the wood absorbs it and wrecks your floor. Best bet are usiing those felt pads or other pads to rasie the tank off the floor a little and preventing it from being scratched. My 2cents. I have 2 tanks both on hardwood and am not too worriend about it. Also, having leveling legs on a stand would be a good idea too, since the floor may not be perfectly level.
Reply With Quote
  #7  
Old 05-01-2007, 12:34 AM
Dragonsteeth Dragonsteeth is offline
Junior Member
 
Join Date: Mar 2007
Location: North Vancouver, BC
Posts: 21
Dragonsteeth is on a distinguished road
Default

Quote:
Originally Posted by 04scoobysti View Post
Yea, but if you put that rubber mat under the tank and you spill any water around the tank it will be stuck between the rubber and the hardwood till the wood absorbs it and wrecks your floor. Best bet are usiing those felt pads or other pads to rasie the tank off the floor a little and preventing it from being scratched. My 2cents. I have 2 tanks both on hardwood and am not too worriend about it. Also, having leveling legs on a stand would be a good idea too, since the floor may not be perfectly level.
For the same reason i am glad my 33g is on felt as i had a hose leak and alot of water hit the deck. I slid the tank over and dried up the mess, then put it back. The rubber pad may prevent you from drying up which will definately affect your floor. My 1 cent worth. Good luck!
Reply With Quote
  #8  
Old 05-01-2007, 12:48 AM
adidas's Avatar
adidas adidas is offline
Member
 
Join Date: Dec 2004
Location: calgary
Posts: 1,098
adidas is on a distinguished road
Send a message via MSN to adidas
Default

water and humidity and hardwood floors don't mix very well.
Reply With Quote
  #9  
Old 05-01-2007, 01:51 AM
mark's Avatar
mark mark is offline
Member
 
Join Date: Nov 2002
Location: Edmonton AB
Posts: 4,212
mark is on a distinguished road
Default

In my old place had the 75g direct on the HW with no problems. Stand had four adjustable feet each probably no more than 1.5" diameter and didn't leave a depression when I moved it after 3+ years.

I didn't place a mat as was more concerned that if I had a spill the water would be trapped. This came partly as when I moved into the house it had carpet throughout, with the original maple HW underneath. When I stripped the carpet there was an area by the door of the bathroom where the wood was warped, so thinking better if wet to dry right away.

Fish tank aside, have split water, beer, juice, milk, had pee etc. on the wood (wondering my lifestyle eh?), with no damage as cleaned up immediately.

Last edited by mark; 05-01-2007 at 02:06 AM. Reason: bad language
Reply With Quote
  #10  
Old 05-01-2007, 01:54 AM
Johnny Reefer's Avatar
Johnny Reefer Johnny Reefer is offline
Member
 
Join Date: May 2005
Location: Victoria, B.C.
Posts: 1,192
Johnny Reefer is on a distinguished road
Send a message via MSN to Johnny Reefer
Default

What about laminate floors? Anyone ever have any problem with water seaping in through the seams?

Thanx much,
__________________
Mark.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 03:06 AM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.