|
|
|
#1
07-28-2006, 08:43 PM
|
|||||
|
|||||
wiring a Iwaki mx-100
Hey peoples........
I just got a new mx-100 Iwaki and yes @#$##$ no power cord. Could you give me some help wiring it please. I will be using 30 amp cord, took off the power box cover found the ground marked G...lol , but the poss and neg I dont want to mess up. Thanks
__________________
Richard _______________________________________ My wife believed me when I told her it was only going to cost about $500.00. that was over two years ago and I'm still grounded..... 
|
|
#2
07-29-2006, 02:55 AM
|
|||||
|
|||||
|
If there is white and black terminal then use black for hot lead (smaller one in the receptacle) and white for neutral. There is no positive & negative it's alternating current.
If it's not marked then it don't matter witch way it goes. You can always check iwaki web. http://www.iwakiwalchem.com/nav/cm.aspx?cmid=35
__________________
Denis 150g SPS reef;3x250WHQI,Tunze Streams,Wavebox,Neptune Apex,fishroom in basement  ,reefing since 93,SPS since 99.TOTM June 2010 Last edited by Denis; 07-29-2006 at 03:02 AM.
|
|
#3
07-29-2006, 03:14 AM
|
|||||
|
|||||
|
Well After looking at the web myself, no help there.
Why don't you take a pic of the connector and we can try to figure it out for ya. It appears that these are a industrial hard wire application pumps, hence no cord. Manual just says wire accordingly to elec. code.
__________________
Denis 150g SPS reef;3x250WHQI,Tunze Streams,Wavebox,Neptune Apex,fishroom in basement ,reefing since 93,SPS since 99.TOTM June 2010
|
|
#4
07-29-2006, 03:56 PM
|
|||||
|
|||||
|
I think I got it.......
Thanx for your help
__________________
Richard _______________________________________ My wife believed me when I told her it was only going to cost about $500.00. that was over two years ago and I'm still grounded.....
|
Linear Mode
