|
#1
|
|||||
|
|||||
Quote:
__________________
Brad |
#2
|
|||||
|
|||||
Don't forget to order a 3rd Jebao so you can replace a dead Jebao around the 1 year mark. But they are cheap, so replacing once a year is no biggie!
|
#3
|
|||||
|
|||||
Exactly. I have a spare. But good PSA.
__________________
Brad |
#4
|
|||||
|
|||||
Hey guys, I have an old tunze I am not using because the mount broke. When I find it, I'll post it up and see if is something you guys can use.
__________________
- S H A O - |
#5
|
|||||
|
|||||
__________________
- S H A O - |
#6
|
|||||
|
|||||
Quote:
Does Apex do 0-5v or 0-10v? I tried setting the Profilux output to 0-5v as suggested, and they only ramped up about 1/2 way... but very quiet. Got home today and both the pumps had stopped again. Grrrrr |
#7
|
|||||
|
|||||
Sorry, honestly don't know. 0-10 sounds right, but I often make stuff up in my head
__________________
Brad |
#8
|
|||||
|
|||||
Just measured the output from the Jebao controller, it's 5v max.
Now the weird part. With the Profilux set to 0-10v I get 4.89v at the control circuit out to the pump. There must be a resistor in the adapter for the Profilux circuit. Temped to just hook them up to an old wave maker power bar. |
#9
|
|||||
|
|||||
Weird. I have all my original tunzes still working. I've only had one motor block and one driver box die out of the lot and they were a questionable setup when I bought them (modified or something). My wavebox is going on 8 years old.
Course now that I've said that they'll all die slowly over the next few months...
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free. |