|
#1
|
|||||
|
|||||
Mine starts to surge if it's taken to far from the 9.5"
__________________
Mike 150g reef, 55g sump, T5's, Vertech 200A, Profilux III - German made is highly over rated, should just say Gerpan made. Reefkeeper - individual obsessed with placing disturbing amounts of electricity and seawater in close proximity for the purpose of maintaining live coral reef organisms. |
#2
|
||||
|
||||
I run both of mine at about 8" of water.
A piece of neoprene (wetsuit material) would dampen any vibration of your stand. Without dampening, the noise from the vibrations may be annoying especially since your tank is in your living area, not in a fish room or garage. |
#3
|
||||
|
||||
Quote:
|
#4
|
||||
|
||||
|
#5
|
||||
|
||||
I have a Vertex Omega150 and have it sitting on 6 stacked egg crate pieces, kinda the same as what you have there. It's in 8" of water and works great, I ran it in vinegar mix when new for 24 hours to remove any oils etc. before I put it into operation in the sump.
__________________
Hey! I never "LEFT" the hobby, just doing fresh water now. Which is still listed as part of Canreef if I'm not mistaken. |
#6
|
||||
|
||||
Ok so I went n bought a vertex omega 150 skimmer put it in 7.5" of water and it's doing the exact same thing as my previous skimmer!!! Either overflowing, come back couple hours n bubbles drop all the way down.. Vice versa. Are the skimmers acting like this because I have no bio load other than super clean rocks and new live sand? My tank is ready for the move but I'm afraid to swap everything from my old tank over till my skimmer problem is fixed. Was thinking about going to buy some fish n try it since I cannot catch any fish in my old tank CUZ they keep hiding in my sps corals
|
#7
|
||||
|
||||
Quote:
Sounds to me like you have nothing to skim yet, I never ran a skimmer for at least a couple of weeks after I set up my 90 g and moved all my livestock from my 50 g tank into the 90 and let the load build. Not sure there's a magic set waiting time before you fire up the skimmer, but it worked for me. Maybe others can chime in.
__________________
Hey! I never "LEFT" the hobby, just doing fresh water now. Which is still listed as part of Canreef if I'm not mistaken. |
#8
|
||||
|
||||
What do you mean by starts to surge ?
__________________
........ |
#9
|
|||||
|
|||||
You see the water level in the neck going up and down and you can also hear it from the pump.
__________________
Mike 150g reef, 55g sump, T5's, Vertech 200A, Profilux III - German made is highly over rated, should just say Gerpan made. Reefkeeper - individual obsessed with placing disturbing amounts of electricity and seawater in close proximity for the purpose of maintaining live coral reef organisms. |
#10
|
||||
|
||||
Mine was doing that. Goes up down n super hard to fine tune. Even adjusting the tuner by a hair line will cause huge fluctuations in skimmer lvl. Found out that my pump was not in straight it was a lil crooked. It now doesn't fluctuate by tuning it is so hard. Is this normal for vertex IN series? Litterly 1 hair turns makes it either g half way down in bubbles or super overflowing
|