Ghl Profilux Discussion And Support Thread

[niloc16]

i figured it out, the connector on the control box for the tunze was a little loose.

[zoomin]

OK, I am ashamed to admit that I cannot figure out how the level sensor kit is supposed to be installed - any pics or documentation out there?

[zoomin]

a little more searching was all I needed:

http://reefcentral.com/forums/showth...5#post12146235

[Aqua-Digital]

Beat me to it.

Let me know if I can help further

[Patrick1]

Originally Posted by zoomin

OK, I am ashamed to admit that I cannot figure out how the level sensor kit is supposed to be installed - any pics or documentation out there?

Thats ok I spent a day working on my auto top off only to find out I had plugged the pump into the wrong socket. YES SMRT I mean SMART...

[niloc16]

it has been 3 times now that the last digital powerbar in the daisy chain has lost connection with the controller. the connection link led is still lit but the controller does not control anything and i have to reprogram the bar. any ideas what the heck it is?

[Todd]

One of my outlets has stopped working on my digital powerbar - it is like there is a bad connection because if I wiggle the cord in the outlet then it works. It is not the fixture that I have attached because I have tried it with other components and it is the same problem. Is there a way of fixing the powerbar so that I can have all outlets working?

I had my MH ballast plugged into the socket that is no longer working (high draw, but it never had a problem firing or with the breaker either).

[Aqua-Digital]

Hi

I will ask Matthias what he thinks. Do you have series 1 or series 2 power bars?

All 15 amp sockets or 8 and 15 amp?

[JoelV]

[qoute]Ihad my MH ballast plugged into the socket that is no longer working (high draw, but it never had a problem firing or with the breaker either[qoute]

Todd,

I have heard of this problem before with Non Profilux equipment. When it comes to a high amp draw like a metal halide light, The plug heats up and cools down (Expands and contracts) more so if the plug is not seated well. Over time the metals warp and no longer connect well.
I would first try and replace your male end with that of a thicker one (Yellow replacement cord end )
the prongs are a bit thicker and may fix the problem of a a worn outlet.

[Matthias Gross]

@niloc:
sound like the transmission to the last powerbar is disturbed.
What is the control cable length between ProfiLux and powerbar (over all, including all connections)?

@Todd:
maybe only a broken fuse - please contact me or Michael directly via email