Skimmer Makeover

[Skimmerking]

Well how about a postive note the quinster. Looks awesome buddy, Now how about helping me get a new sump .

mike

[takphan]

Originally Posted by Quinster

like I said I was using the MAG 18 for both...so either way I am using the same power...the foam difference made it worth it in my opinion...unless if I had a better Venturi from the start...maybe I wouldn't have changed it.

look awesome Quinn

IMO, the satisfaction of DIY project is DIY.

Tak

[Quinster]

danny zubot : don't know how a needle wheel pump would work on these types of skimmers...never had one running on this application...maybe someone could shed some light on this...

takphan : thanks for the comments...like to try if I can

[danny zubot]

I think I might have to get my friend's needle wheel and try it out. I think there would be less adjusting to do if it did work.

[mr_alberta]

Danny, are you going to use a needle wheel pump to drive a Beckett or are you going to add one as a recirculation pump on the skimmer?

I doubt it would drive a Beckett very well, and a recirculating pump on a beckett isn't really needed (though it should boost performance).

[Quinster]

Tried another change...hooked up a 1 1/2" clear down tube now...looks cool, and bubbles seem to flow better and smaller.