Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Tank Journal

Reply
 
Thread Tools Display Modes
  #101  
Old 03-14-2012, 05:50 PM
lockrookie's Avatar
lockrookie lockrookie is offline
Member
 
Join Date: Dec 2009
Location: regina
Posts: 1,535
lockrookie is on a distinguished road
Default

Quote:
Originally Posted by gregzz4 View Post
So, starting over?
Sounds like me with my sump. I've run it through my mind for the last month and a half, and I think I finally like it.
I had to smash my baffles/bubble trap and re-do what I thought was a beautiful sillycone job. I had taped everything and it looked pro.
Now, after re-doing it with the layout I decided on, it looks like someone's Kindergarten class did it for me. I couldn't get the gun in there, and did not have any 300ml tubes on hand. I had to run all the inside seams by applying small beads with my finger tip.
How do these builders make these custom tanks look so nice ?
I even tried to tape things off, but you can't remove the tape from those little places.
AAACCCKKKKK
i checked the tank this morning and it seems to actually have sealed quite nicely the questionable areas are just messy and not as tidy as i hoped to be but i can live with that since they will be under the sand bed

but i did recieve my glass hole saws today so i know what ill be doing this weekend...building my overflow drilling holes finishing eurobrace install. ill have it all water tested by next week just in time to set it aside and get ready for the inlaws to come visit for a month. dont get me wrong i will be doing stuff durring that month once the overflow is built i can then begin my rockwalls and flow hiders most of that can built without the tank laying flat.
__________________
Desperately seeking serenity ...
180g custom build
http://www.canreef.com/vbulletin/showthread.php?t=81400

50g custom daycare tank...
http://www.canreef.com/vbulletin/showthread.php?t=65428
Reply With Quote
  #102  
Old 03-16-2012, 07:12 AM
lockrookie's Avatar
lockrookie lockrookie is offline
Member
 
Join Date: Dec 2009
Location: regina
Posts: 1,535
lockrookie is on a distinguished road
Default

the part of this project that scares the #$%& outta me but it has to be done for this to work.. notching the eurobrace for access to the overflow. i am only notching out 2" of the 4" brace.by 20" long .the overflow is going tobe 18" x 5". 1/2" of that will be sitting on the glass to leave me with a total opening area of 3 1/2" not alot of room but enough if the need arises.



*disclaimer*

i am not a glass expert nor do i claim to know what im doing this is more of an experiment due to need, i do not have the tools to polish and make it look pretty and sparkly when finished (if it works and doesn't break). so if your expecting something sparkly from this diy'r im sorry im not worthy. if i have the time and can rent the tools later i may try to spit polish the glass later all in all it will be under a hood in the end and i dont care how purdy it is. now pray for me that it works. i really dont want to buy another piece of glass
__________________
Desperately seeking serenity ...
180g custom build
http://www.canreef.com/vbulletin/showthread.php?t=81400

50g custom daycare tank...
http://www.canreef.com/vbulletin/showthread.php?t=65428
Reply With Quote
  #103  
Old 03-16-2012, 01:17 PM
fishytime's Avatar
fishytime fishytime is offline
Member
 
Join Date: Mar 2007
Location: E-town
Posts: 5,390
fishytime will become famous soon enough
Default

May the force be with you
__________________
260g mixed reef, 105g sump, water blaster 7000 return, Bubble King SM 300 skimmer, Aqua Controller Jr, 4 radions, 3 Tunze 6055s,1 tunze 6065, 2 Vortech MP40s, Vortech MP20, Tunze ATO, GHL SA2 doser, 2 TLF reactors (1 carbon, 1 rowa). http://www.canreef.com/vbulletin/showthread.php?t=50034 . Tank Video here http://www.vimeo.com/2304609 and here http://www.vimeo.com/16591694
Reply With Quote
  #104  
Old 03-16-2012, 04:25 PM
lockrookie's Avatar
lockrookie lockrookie is offline
Member
 
Join Date: Dec 2009
Location: regina
Posts: 1,535
lockrookie is on a distinguished road
Default

thanks fishytime iwill need the force and a stiffdrink to calm my nerves. lol like i say if it breaks ill just go to plan b and make the overflow out of heavier glass to support the back wall. always have a plan b
__________________
Desperately seeking serenity ...
180g custom build
http://www.canreef.com/vbulletin/showthread.php?t=81400

50g custom daycare tank...
http://www.canreef.com/vbulletin/showthread.php?t=65428
Reply With Quote
  #105  
Old 03-16-2012, 05:09 PM
Coralgurl's Avatar
Coralgurl Coralgurl is offline
Member
 
Join Date: Aug 2011
Location: Calgary
Posts: 1,894
Coralgurl is on a distinguished road
Default

Sending good vibes your way that all will go as planned!!!
Reply With Quote
  #106  
Old 03-16-2012, 05:56 PM
lockrookie's Avatar
lockrookie lockrookie is offline
Member
 
Join Date: Dec 2009
Location: regina
Posts: 1,535
lockrookie is on a distinguished road
Default

we will see if i get time this afternon i may give it a try... or ill chicken out and wait until tomorrow... my bulkheads should arrive today as well as my 2 koralia powerheads. i hope to clean an area in the garage as well so i can start on the stand.
__________________
Desperately seeking serenity ...
180g custom build
http://www.canreef.com/vbulletin/showthread.php?t=81400

50g custom daycare tank...
http://www.canreef.com/vbulletin/showthread.php?t=65428
Reply With Quote
  #107  
Old 03-16-2012, 06:17 PM
Skimmerking's Avatar
Skimmerking Skimmerking is offline
acanthastrea freak
 
Join Date: Jun 2002
Location: Virden, Manitoba
Posts: 5,688
Skimmerking is on a distinguished road
Send a message via ICQ to Skimmerking Send a message via MSN to Skimmerking
Default

no one like a quitter go for a Jeff
__________________
180 starfire front, LPS, millipora
Doesn't matter how much you have been reading until you take the plunge.
You don't know as much as you think.
Reply With Quote
  #108  
Old 03-16-2012, 08:36 PM
lockrookie's Avatar
lockrookie lockrookie is offline
Member
 
Join Date: Dec 2009
Location: regina
Posts: 1,535
lockrookie is on a distinguished road
Default

Quote:
Originally Posted by Skimmer King View Post
no one like a quitter go for a Jeff
not gonna quit just needs some liquid encouragment. cant do that til dayare kids leave
__________________
Desperately seeking serenity ...
180g custom build
http://www.canreef.com/vbulletin/showthread.php?t=81400

50g custom daycare tank...
http://www.canreef.com/vbulletin/showthread.php?t=65428
Reply With Quote
  #109  
Old 03-16-2012, 09:53 PM
lockrookie's Avatar
lockrookie lockrookie is offline
Member
 
Join Date: Dec 2009
Location: regina
Posts: 1,535
lockrookie is on a distinguished road
Default

soooooooooooo i braved it. and this is my result



__________________
Desperately seeking serenity ...
180g custom build
http://www.canreef.com/vbulletin/showthread.php?t=81400

50g custom daycare tank...
http://www.canreef.com/vbulletin/showthread.php?t=65428
Reply With Quote
  #110  
Old 03-16-2012, 10:03 PM
cuz's Avatar
cuz cuz is offline
Member
 
Join Date: May 2009
Location: lethbridge
Posts: 601
cuz is on a distinguished road
Default

Not to shabby!!!!!!!! Nice work!!!

Did you cut or score from hole to hole?
Reply With Quote
Reply

Tags
180 gal tank, custom tank, diy, reef build


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 11:16 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.