NEED HELP WITH MP10

[Cujo#31]

Originally Posted by rusty shackleford

Did you try clearing the memory on it ?

And when I swap circuit boards the driver works perfectly on other side. If I hook working driver to faulty side I get same fault code.

[rusty shackleford]

Try holding the mode button , does it respond at all ?

[Cujo#31]

Originally Posted by rusty shackleford

Try holding the mode button , does it respond at all ?

Ya.....it responds by flashing red/green. I just did hard reset again by switching board to other side and still nothing

[rusty shackleford]

So you're saying that from the time you plug it in , right off the bat it's red/green and will not respond to anything ?

[Cujo#31]

Originally Posted by rusty shackleford

So you're saying that from the time you plug it in , right off the bat it's red/green and will not respond to anything ?

I get one, maybe two cycles of red green yellow (in that order I believe) then right to red green. Even if I'm holding mode and set buttons when I put in power supply it does not respond at all. Conversely. If I hook the "faulty" circuit board to the other side...perfect function. The wet sides each work perfectly on the right side. The circuit boards work perfectly on the right side. The left (origins fault side( has the NEW dry side... and still jack squat

[Cujo#31]

I can't imagine J&L would have sold me a brand new malfunctioning unit

[Cujo#31]

I'm going bloody insane. This should not be that difficult. I'm up at 4 am so gotta crash. When I get home, just for the sh#ts and giggles of it I'm going to take the old, functioning dry side on the right, and swap it with the new, malfunctioning side on the left. That is the ONLY thing I haven't tried.

[rusty shackleford]

When you're doing the reset are you doing it on the tank coupled with wet & dry sides together ?

[Cujo#31]

Both ways. Coupled together dry, aligned and in functioning position on tank......