Vertex ro/di help

Skimmin · #1 03-13-2015, 05:23 AM

Mine has been running at 150 to 160psi since day one. No chloramines here. Been running it for 4 months, still reading 0ppm on the tds. I guess one big thing here is our water pressure here is really high at about 100 psi. If I had lower inlet pressure I might be concerned. Typically you never see over 80 psi for a building pressure (80 psi is code maximum)but there is no pressure reducing valve here to keep it lower. On a good note for making rodi I was happy to see I had such high pressure.

Myka · #2 03-13-2015, 03:35 PM

My understanding is that the main concern is the fittings and housings being able to handle the pressure as I understand most are rated for 100 psi working pressure. The membranes themselves can handle something like 250 psi as far as I know. I'm not sure though, all I know is I'm not comfortable with the unit running at 150 psi.

Myka · #3 03-13-2015, 09:59 PM

Here's the reply I got from Proline Aquatics.

Quote:

We recommend the units to be run between 90-100 PSI. If someone runs one of the Deluxe units (the units with a booster pump) and they already have a high PSI coming out of the taps, the booster pump can push it too high….this is likely what is happening for these folks. This will reduce the length of time the membrane is effective.
You can put a limiting valve between the water source and the unit to reduce the pressure so that you can still use the Deluxe unit and not have this high PSI issue. Alternatively, we also have a basic unit with no booster pump.