![]() |
#15
|
||||
|
||||
![]() Quote:
you can measure the output of the reactor it should be less than the display, if it is more than that , it is exhausted. at about 300gph turnover through gfo reactor your going to turnover your whole tank a few times a day , so the first initial batch will get used up very quickly. once numbers get down a batch can last longer depending on your phosphate source. if you are running it passive then you can be getting more bang for your buck with a fluidized reactor. the reason why it is hard to become nitrogen deficient is simply the imports of foods and fish waste/ ditrius buildup has to be exported faster then they are added.with smaller systems this can be achieved by water changes too often and too large using good source water ,low biolaods or no bioloads etc. but in an average ran aquarium water changes are weekly/ or longer and the buildup of of nitrates is daily so therefore corals are getting what they need daily as they build up. with Po4 alot of people use gfo or other binding products and run it 24/7 so you can become phosphorous limited , but the additon of daily foods keeps it in check unless the limits are pushed. so if you were to add a removal source for nitrates that was daily that can out compete your daily inputs of n , like bacteria can, then you can become nitrogen deficient ![]() |