Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > DIY
Reload this Page cutting 6" Pipe
Portal PhotoPost Gallery Register Blogs FAQ Members List Calendar Today's Posts

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #13  
Old 09-23-2004, 05:30 AM
Richer's Avatar
Richer Richer is offline
Member
  
Join Date: May 2004
Location: Edmonton (Southwest), AB
Posts: 784
Richer is on a distinguished road
Default
Looks like rails were put on the bottom of the jig to slide through the notches on the tablesaw... probably would be wise to clamp it down while you're using it.

-Richer
Reply With Quote
 

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 06:32 AM.

Contact Us - Canreef Aquatics - Archive - Top

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.