Scott's 135 gallon display tank build

[patman]

Looks great. Denny and I are going to start talking about my build tomorrow. Looks similar, but I'm going with a cube (I think). Where are you going to put the sump? Doesn't look like there is enough room below for the skimmer? unless your kid is a giant

[Gp Scott]

Originally Posted by patman

Looks great. Denny and I are going to start talking about my build tomorrow. Looks similar, but I'm going with a cube (I think). Where are you going to put the sump? Doesn't look like there is enough room below for the skimmer? unless your kid is a giant

I put my sump in the basement because I had everything there I needed water,sewer drains,power I added 3 gfi in mech room for it. When I cut my floor I made it the same size as a floor register so if we decide to move I could pull the tank and drywall and put in register in

[WarDog]

Nice looking build! If I may make an observation, I don't see a valve on your Herbie.

[Gp Scott]

Originally Posted by WarDog

Nice looking build! If I may make an observation, I don't see a valve on your Herbie.

Not sure what you mean about a valve on the herbie ? But this is what I put on the main drain it's a dorso water flows thru 90 into T with a cap and hole in it so I always have air after water I could also put a valve on top too to regulate the air. The other pipe is emergency. I would never put a valve on a drain.

[mihaivapler]

To be able to have a quite herbie overflow you need a valve to be able to cut down the flow so it is quite.it has to be installed on the main drain just under your union.

[WarDog]

Originally Posted by mihaivapler

To be able to have a quite herbie overflow you need a valve to be able to cut down the flow so it is quite.it has to be installed on the main drain just under your union.

Yeah, what mihaivapler said! Personally I would recommend the valve just above the sump, this enables you to run full siphon the entire length of the pipe. Only the short section of pipe after the valve will have any air in it (which makes all the noise). Also this increases your overall water volume. A properly tuned Herbie is silent.

------> http://gmacreef.com/herbie-overflow-...method-basics/

[mihaivapler]

i have it the same,just before flows in the sump,but in his case having the sump in the basement it will be very hard to adjust it..and must be a gate valve,the regular valve it is very hard to adjust..you can see in the picture,the left pipe is the emergence and the right one is the main drain whit a 1" gate valveAttachment 13077

[Gp Scott]

Originally Posted by WarDog

Yeah, what mihaivapler said! Personally I would recommend the valve just above the sump, this enables you to run full siphon the entire length of the pipe. Only the short section of pipe after the valve will have any air in it (which makes all the noise). Also this increases your overall water volume. A properly tuned Herbie is silent.

------> http://gmacreef.com/herbie-overflow-...method-basics/

I just noticed the link you posted that clears it all up for me I think I will try the valve when I get water back into the tank. But I think I should try and put it in the basement at sump just so my kids don't mess with it. It might be tough to tune in because my pump is T of to refuge and any extras.