Free - AEFW

[Wheelman76]

I just finished setting up my new tank , 36"x30"x20" tall. Will be sps only with lots of flow , bare bottom and I have the 36" 8 bulb ATI hybrid light over it. Loving the dimensions of this tank

[Aquattro]

Originally Posted by Wheelman76

I just finished setting up my new tank , 36"x30"x20" tall. Will be sps only with lots of flow , bare bottom and I have the 36" 8 bulb ATI hybrid light over it. Loving the dimensions of this tank

Sorry, the pics didn't show up

[Proteus]

Brad with a 400w how high would you hang that light. there's alot of lumens beaming down. In my shallow tank its 12" with a 250w

[Aquattro]

Originally Posted by Proteus

Brad with a 400w how high would you hang that light. there's alot of lumens beaming down. In my shallow tank its 12" with a 250w

Not sure. Probably 10 or 12 inches. Height will be determined by spread. Using a lumenarc reflector, so spread should be enough for most of the area. Not too concerned with intensity, the corals can handle it fine. Supplementing with 2 T5 superblue for pre/post daylight.

[Reefer Rob]

Why not a 36" cube? Your halide light pattern is square anyway

[Aquattro]

Originally Posted by Reefer Rob

Why not a 36" cube? Your halide light pattern is square anyway

Too big, would stick out too far into the room. I had a 36" cube frag tank, and found it tough to work in.

[StirCrazy]

Originally Posted by Aquattro

Too big, would stick out too far into the room. I had a 36" cube frag tank, and found it tough to work in.

you should see if my old tank is still floating around vic somewhere not being used.

Steve