MP 10 Dry Side Bearings

[gregzz4]

Yup, those are the correct 2 different sizes they came with
There's no way to tell which ones you have until you remove them from the housing
Be VERY careful not to chip the magnetic shaft assy - don't try to pry them off the shaft
I've tried the freezer trick for removal but I didn't have any success. Nor did it help to re-install them

I've tried 3 different styles of bearings and have found these ones to be the quietest so far
It took about a month at full speed on EcoSmart before they became as quiet as they'll get

If you need the 6X15mm ones you'll need to contact them for the correct p/n, but I'd recommend the style I linked

If you have any questions, shoot me a PM

[Maverick00]

Thanks for the great info guys!

gregzz4 if i do attempt to do it here ill throw you a pm.

To my surprise alot of the noise was coming from the wet side, even though i cleaned it over and over again. The dry side is still noisy but i find it more irritating than ever because i started running it at 100%.

As frustrating as it is i must say I am very happy overall with the pump. I actually bought it used a couple years ago so its defiantly seen some use. I did however have to buy a new control unit for it as well a few months ago.