Ca reactor feed

[SuperFudge]

Tony,

If there are any other ballvalves in the line that is being used for the reactor feed say,to a skimmer,the pressure to your reactor changes when they are adjusted.....this slows or increases both your bubble rate and effluent rate.
The more tee`s that are used,the worse it gets.

Shao`s original complaint was that his effluent rates were inconsistant,and i didnt want him to end up with the same problem.

Shao,sounds like you dont have any PVC fittings other than barb fittings on there?
Do You have another pump running the skimmer ?

[ 25 September 2002, 16:41: Message edited by: Superfudge ]