|
|
|
||||||||
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
01-19-2014, 12:41 AM
|
|||||
|
|||||
Something is not right here. Either your bulkhead threads or your MPT threads are hooped, or are not MPT at all, but you have used two and are seeing the same results. Hmmm. I have 2 suggestions. 1) Teflon goes clockwise around the threads, so as it doesn't unwind as you tighten. 2) You may want to use wrenches to assist in tightening, however go slow and careful not to split female threads. If all else fails get yourself some slip slip bulkheads. Hope this helps.
|
|
#2
01-19-2014, 04:55 AM
|
||||
|
||||
|
The threads are not damaged. I took my return and a spare MPT SLIP to JL this morning to test fit. They were all really tight.
Teflon tape is wrapped clockwise, basically in the same direction as tightening the return. Im shying away from using wrenches to tightening just in case I need to remove for maintenance. Thanks for the insight. Last edited by byee; 01-19-2014 at 04:59 AM.
|
Hybrid Mode
