Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Marine Fish

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #9  
Old 12-17-2013, 06:57 AM
craigwmiller craigwmiller is offline
Member
 
Join Date: Sep 2012
Location: Edmonton
Posts: 233
craigwmiller is on a distinguished road
Default

Can't trust a wrasse not to jump, so save them from themselves and put a screen cover.

I use a piece of plastic chicken wire (3/8" squares) which attaches to the top of the euro bracing with 3M Command clips. (takes about 15 seconds to take the entire screen off, but normally I just take of 2 or 3 points in a few seconds to add a fish or move a frag/etc.

My most recent install of the chicken wire on my latest tank was about 2 hours after I added a fairy wrasse. (I lucked out trusting a yellow, a mccoskers, and a couple leopards previously, but since I had the stuff I decided not be be lazy)... About an hour after the 10 minute install, I fed the fish and the new wrasse decided to eat (YAY) and then get intimidated by my powder brown and dart out of the water, deflecting the net by about 3-ish inches... I cheered since it was a good show and that he wasn't able to commit suicide!


Cover it, wrasses & blenny's get startled easily and can leave the water.
__________________
Single System Setup: 210G SPS reef, 225G FOWLR, 72G water change, 50G frag, 120G sump. I promise a journal at some point! (anyone need some coral frags? I likely always have stuff that is frag-ready)
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 06:28 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.