2-part Soda Ash and Calcium in BULK NOW AVAILABLE

[LoJack]

Do you have any reference for the concentration of your product when mixed to your specifications?

The product I use now, I know that 1ml of solution, will raise the calcium level in 1 gallon of water by 10 ppm. (obviously you need to test to get your particular dosing right, I'm basically trying to associate a Dollar Value to each ml of solution after mixed)

I'm trying to figure out the value of the concentration.

I don't want to switch to a different bulk chemical, if the concentration is lower to the point that its going to take me 3ml to make the same change in my water.

I use a ton of solution in my current SPS tank, and its not only about value, but how long my 5 gallon pail of solution will last at my current dosing rates.

[LoJack]

Oh, And has anyone tried these chemicals yet … I know everyone is waiting for a guinea pig, has there been one yet?

[mrhasan]

Originally Posted by LoJack

Oh, And has anyone tried these chemicals yet … I know everyone is waiting for a guinea pig, has there been one yet?

I am using both Ca/Alk. Haven't seen anything to be concerned about.

[LoJack]

Originally Posted by mrhasan

I am using both Ca/Alk. Haven't seen anything to be concerned about.

Well bud you are a good spokesman, considering I just commented on the quality and health of your Red Dragon or (Mr. Pacman)

I just wish there was a chart for the values of the product or a calculator that shows Cal and Alk increases per ml.

[mrhasan]

Originally Posted by LoJack

Well bud you are a good spokesman, considering I just commented on the quality and health of your Red Dragon or (Mr. Pacman)

I just wish there was a chart for the values of the product or a calculator that shows Cal and Alk increases per ml.

Thanks

Well its just Randy's 2-part receipe 1 so I used reef calculator to calculate and adjust a bit. Like 25ml of Alk increases my Alk by 0.6-0.7 while 200ml of Ca increases my Ca by 30-40.