|
|
|
#12
11-29-2013, 12:18 AM
|
|||||
|
|||||
you could do it fairly easy, just need one of these, and yours drill bits have to fit it.
http://www.leevalley.com/en/wood/pag...at=1,180,42316 most diamond hole saws have built in shafts though so might not work. other option is to just drill around it, if you start on an angle and then shift to flat it shouldn't be to difficult, just use less pressure than normal and take your time. other wise get a new chunk of glass and redrill it, (this is on your overflow is it not) would be cheep for a small chunk of glass. Steve
__________________
 *everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive. 
|
Threaded Mode
