For all the gearheads out there

[gregzz4]

Can't for sure say why it failed
All I can think of is it slipped down a bit during the install, and the gasket ports are 'just' a bit big, allowing it to find an edge of the head
Then over time it failed

This last set of gaskets was on there for 2-1/2 years without issue 'till the middle of October, so go figure

I checked the intake with a straight edge and all is good
I checked the intake bolts before removing and all was torqued

No explanation here, but I'm just a hack with this stuff

As I stated earlier, I used some 'poop' this time to keep the gaskets centered over the ports and expect this to work