DIY 16x15x16 Acrylic AIO 16 Gallon

[nrosdal]

Originally Posted by byee

Nick,

Do you run the router at the slowest speed to keep the router bit from getting too hot from melting the polycarbonate?

I've built a few things here and there for my setup but nothing that nice.

I typically run my polycarbonate through the table saw to get a finished edge therefore leaving my with 1 edge to glue with MC.

I'm going to have to try your approach.

Once again, you're an Artisan with polycarbonate!

I run router at normal speed as mine is just on/off. If you are using just a 2 flute bit it will not melt the acrylic usually. I run acrylic through table saw and leave an extra 1/4 to take off with router as edge is much better after routing. After that you can either bond it or hit it with 600/800 grit for a few strokes not to much as it is likely to round edge.

Hope this helps. I am just in the process of building a little container for the top off for this tank and will post it in here a bit later on when finished.