![]() |
|
#1
|
|||||
|
|||||
![]() Quote:
![]()
__________________
Always looking for the next best coral... 90g starphire cube/400mhRadium20k/2 XHO/2x27w UV/2x39w T5/ 3 Trulumen led strips |
#2
|
|||||
|
|||||
![]() My Mg has been running about 1260 ppm lately (used to be around 1400), so decided to start raising it with manual dosing. Yesterday I added 125 grams of Seachem Reef Advantage Magnesium to a 230 gal water vol. This is only 1/2 the maximum dose they recommend for one day. And to raise it all the way to 1350, their dosing calculator says I need to add about 8 or 900 grams, which seems like a lot to me.
So today, I test my Mg again to see what effect it had. And to my surprise, my Mg is now higher than 1500, which is the max I could test for with my Salifert test kit!! WTF!!! It should only have gone up by maybe 10 - 15 ppm according to their instructions. I reread and reread the instructions, and did more research on the web, but can't figure out what I did wrong. I also tested my alk (8 dKH) and Ca (400 ppm) and it did not change much from yesterday. And everything in my tank(s) look normal. I will test again tomorrow. But any ideas what is going on here??
__________________
Reef Pilot's Undersea Oasis: http://www.canreef.com/vbulletin/sho...d.php?t=102101 Frags FS: http://www.canreef.com/vbulletin/sho...d.php?t=115022 Solutions are easy. The real difficulty lies in discovering the problem. Last edited by Reef Pilot; 09-28-2013 at 10:10 PM. |
#3
|
||||
|
||||
![]() Strange maybe your initial test was off?
I have used lots of seachem products (mainly my old planted tank) but a few for SW and Their magnesium is the single only product I haven't liked. My mg was low and over like 2 weeks I had dumped the entire 600 g tub in with no increase. I got some mag. From little silver max and his product rasied it exactly what he said it would with an online calculator. My guess is your original testing was off
__________________
250G DD LED SPS R.I.P. 180G LED SPS 80"x36". 300G custom build Owner of Mountain Ridge Heating and Gas Class A gas fitter, HVAC |
#4
|
|||||
|
|||||
![]() Tested again today, and it came in at 1290 which makes more sense. My guess is that yesterday I may not have pulled in the test solution to the top mark in the syringe. I have tested Mg many times before, and never had a bad test, so a little strange that it would happen right after adding Mg.
Anyway, will add more MG today, and keep tracking it.
__________________
Reef Pilot's Undersea Oasis: http://www.canreef.com/vbulletin/sho...d.php?t=102101 Frags FS: http://www.canreef.com/vbulletin/sho...d.php?t=115022 Solutions are easy. The real difficulty lies in discovering the problem. |
#5
|
|||||
|
|||||
![]() I had the same issue with seachem mag and there calculator. I ended up cutting the recommended dose in half and making sure the tanks water mixed for 2 hours before retest
|
#6
|
|||||
|
|||||
![]() Yeah, it definitely doesn't mix easily. Just added another 125 grams this morning, and will test again tomorrow to see if it brings up my Mg. I bought the 600 gram size, so I might as well use it up.
__________________
Reef Pilot's Undersea Oasis: http://www.canreef.com/vbulletin/sho...d.php?t=102101 Frags FS: http://www.canreef.com/vbulletin/sho...d.php?t=115022 Solutions are easy. The real difficulty lies in discovering the problem. |
#7
|
|||||
|
|||||
![]() You should usually test 6 hrs after dosing... Ideally 12 hrs as it will stabilize.
I dosed alk before and tested 1 hr after a larger dose. It skewed the test as it was sitting at 10dkh from 7 originally, tested 24 hrs later and it was at 7.5.... Conclusion, It is best to test the next day after dosing.
__________________
Always looking for the next best coral... 90g starphire cube/400mhRadium20k/2 XHO/2x27w UV/2x39w T5/ 3 Trulumen led strips |