|
|
|
|
|
#1
08-10-2013, 04:06 AM
|
||||
|
||||
The 200M rectangular filter sock by Eshopps will last about a week before needing to be swapped and it's synthetic so it's strong. But because I've learned to allow microorganisms to flow right through the sump 20hrs a day to feed the dt's sponges and gorgs, I have a tee that's directed both to the sock and the skimmer chamber. During feeding, I close a valve and all the flow is directed to the sock and keeps the sump clean...great DT polisher too.
__________________
"The Cavernous Reef" - 180g RC Build In-Progress: Miracles (72x24x24) 3-Sided Starphire; 2X exterior overflows; closed loop w Speedwave 1320; SRO 3000int; Speedwave 2640 return; Aquatronica controller with 3x dosing pumps; 2X Maxspect Razor 160w; 2X MP40wes, 2X MP20; 54" acrylic sump with ATS. Corner 90g Reef. 
|
|
#2
08-10-2013, 05:27 AM
|
||||
|
||||
|
My plan is to have the tank water empty into an area thats baffold is 2 inches from the top of the sump, this chamber will have chaeto in it. I am planning for the returning water to stir and swirl the chaeto...
Then when it over flows that baffold there is a flat shelf that's about 6" long with a 1 cm high water stop at the end. In that flat shelf I will set the 3-4 4" holes for socks so water can just flow down into the sock into the next chamber. If it over flows it needs the 1 cm of flow to go over the water stop and overflow into the next chamber unfiltered....
|
Hybrid Mode
