Daplatapus's upgrade

[ScubaSteve]

Try Niki Glass in Van. With shipping it still might be cheaper.

[daplatapus]

Well, found a place in Vic that'll get me my glass for just shy of $300. Gonna pick it up on Friday.
So no use in letting fear and common sense stop me from carrying on, Started my trim removal tonight:







Still have a lot of silicone to clean up, that'll probably take the next few days to get her nice and clean. I have a couple tubes of GE SCS1200 for setting the eurobrace on.

[daplatapus]

Went in to Vic yesterday to get my glass. Not bad, all the glass I needed, a corner protector I got to cover a small chip and to protect the one exposed corner of the tank, 2 tubes of SCS 1200, all for $250. Not bad I didn't think.

So guess what I'm doing on and off today?

[daplatapus]

Started siliconing my overflow box first. Made up a couple plywood squares to help hold everything. All prep done and ready:



Left side on:



Right side:



And the corner seam:



Not too shabby. I'm fairly pleased. I'll wait until it all sets up and I'll put the bottom on after.

Now the 72" pieces for the euro brace

[b09u5]

Those plywood squares are simple genius! I am new to this, so I am not sure if they are common or not, but I would have never thought them up.

The build is looking great.... I am looking forward to seeing the rest! Thanks for sharing.

[Skimmerking]

looking really good. well done

[daplatapus]

Originally Posted by b09u5

Those plywood squares are simple genius! I am new to this, so I am not sure if they are common or not, but I would have never thought them up.

The build is looking great.... I am looking forward to seeing the rest! Thanks for sharing.

Haha, thanks. But in all honesty, it took me an hour of looking around my shop and basement wracking my brains how I was going to keep this stuff square. I had one small square and I was thinking, if only I had 3 more, lol. Then it hit me to make my own. It did take me a couple tries to get my saw perfectly square though. I was too lazy to set up my good one from my work trailer so I was using my old DeWalt compound.

Originally Posted by Skimmer King

looking really good. well done

Thanks, man. I've got the eurobrace done as well now but have no photo's yet. I'm trying to get a hold of a couple guys now to haul this thing out to my shop so I can stand it on end and silicone the overflow box onto the left side. Then I'll set it up in the garage and fill 'er up and hopefully she won't blow
But if she does, there a lot less explaining to do if it goes out there than if it's in my living room.