New Jarduino build gets started

[mike31154]

I guess I'm too late with this advice, but on connectors with that many pins packed tightly together, it's often a good idea to have a piece of heatshrink on the wire before soldering. Once the pin is soldered up, slide the heatshrink down over the pin & shrink. This minimizes the chance of pins shorting together via a strand of wire or blob of solder. You did a fine job with the soldering so shorts are unlikely once things are buttoned up, but adding the heatshrink was a requirement for the work I used to do. It was great to work on the newer equipment with crimp pins that were pushed into the connector after assembly. With the proper insertion/extraction tools, these connectors were a pleasure to work on, but I wouldn't want to pay for that stuff out of my pocket.