|
|
|
|
|
#1
04-28-2013, 07:03 AM
|
||||
|
||||
Quote:
These changes will work. Low = on and high = off. Intermittently, this logic used to turn the relay on & off will work backwards because of the opto-iso. Jamie does have a SSR (solid state relay) setup which is installed & wired directly behind the outlet. This setup is the most stable and the quietest - SSR don't make the mechanical latching sounds. I hope this helps! 
|
|
#3
04-30-2013, 05:31 PM
|
|||||
|
|||||
|
Quote:
Scubasteve: Sweet, thanks!
|
|
#4
04-30-2013, 06:47 PM
|
||||
|
||||
|
Quote:
__________________
Wow! That's Crazy! Why would you spend that much and go through all that trouble? 
|
|
#5
05-01-2013, 03:53 PM
|
|||||
|
|||||
|
Well again another very early morning thanks to the ever so diligent crows and robins
 Oh, well, might as well do something constructive. This is what my office now looks like, lol  And I got everything hooked up and it seems to be running, yaaaaaaay  The Arduino up and running the code:  And a shot of the panel box everything is mounted in temporarily:  I'm still waiting for my amphenol connectors that's why everything is only temporarily connected. I couldn't think of another way to test fire everything at once to make sure it all worked together. I also want to get this thing over my 77 gal and see if it has a positive effect on the coral and algae I just can't seem to kick. I do have MH bulbs that are 8 months old or so and at this point I'm not buying bulbs with this thing so close to operational. I also have not finished my fan circuitry so right now the fans are not running on my heatsinks so that's next on the priority list. I also have to fine tune the Arduino code because I have a couple channels used that the original code was using for sump lights and such that I'm not using. So I have to figure that out. Anyway, that's an update for now. Hope ya'll enjoy. It appears to be getting lots of views but it's so quite in here 
|
|
#6
05-02-2013, 03:24 PM
|
|||||
|
|||||
|
Got a question for all you wiring guru's. I want all my components housed by my arduino, I really don't want anything sitting on a heatsink. For ease of replacement/service, I also didn't want to link the LED's to each other. I want to be able to remove a fixture and not have it affect the other 2. So I have thus far gone to fairly great lengths in planning to accomplish that. BUT, turns out I'm 1 wire short to my fixtures, DU'OH!!!!!!
I have 8 strings of lights = 16 wires. My fan requires 3 wires for power and PWM and the heat sensor for the heatsinks require 3 wires. For a total of 22 needed wires. But the wire I have only has 21 Is there any way I can share a wire in the fan/sensor circuitry? Or am I going to have to run 1 single wire for my sensor or fan?
|
|
#7
05-02-2013, 04:45 PM
|
||||
|
||||
|
What kind of heat sensor are you using? I imagine that the sensor and the fan could share a common ground.
|
Hybrid Mode
