|
|
|
|
|
#1
04-15-2013, 11:45 PM
|
||||
|
||||
LOL... I completely missed that. I had to go back and look at the pic’s, I thought I missed a post with a tank shot or something. It IS a sweet looking hammer though.
__________________
All spelling errors are considered intellectual property of its owner, and are not to be tampered with 
|
|
#2
04-16-2013, 09:33 PM
|
|||||
|
|||||
|
So, I'm re-thinking my connector issue. Just my LED's are going to take 16 wires. The heat sensor takes 3 and the PWM fans take 3 for a total 22. Been thinking of going with a DB25 connector affixed right to the heatsink and a breadboard mount DB25 by the arduino with a disconnect-able cable between them for each LED fixture. Any thoughts?
|
Hybrid Mode
