Proteus' Shallow reef build

wmcinnes · #1 04-09-2013, 03:09 AM

Looking awesome buddy

TheMikey · #2 04-13-2013, 02:22 PM

What are the dimensions of your external overvlow box? Moreover, what is the depth of your cut for the weir?

Proteus · #3 04-13-2013, 02:34 PM

Over flow is 12"w x 6"d x4"

Cut out is 2". If it is to low ill put a piece on glass behind it

TheMikey · #4 04-13-2013, 03:52 PM

Thanks for the quick response! I'm currently planning out a semi-cube with an external overflow and trying to figure out what successes people are having with different kinds of designs. Yours looked to be about what I was looking to do. I have smaller dimensions, but was thinking of something very similar.

Zoaelite · #5 04-13-2013, 03:58 PM

Dayyummm this is a sleek looking build, I really want a wood cabinet now

.

Your going to love those tiles, I'm a little blown away at how quick the coralline took. You will have a quick green session but over a couple months the purple starts growing and it starts to look really good.

Not sure about SPS but my zoas have no problem growing right on it.

Proteus · #6 04-13-2013, 06:25 PM

It wouldn't take much to skin your stand where it sits Levi

I'm just waiting on a pump. Then it gets wet. I'm filling the skimmer section of sump with rubble from exsisting tank to help with seeding the Marco rock. Also have the reactor full of seeded hydroton also. So I should be ok to set up ASAP.

As for sps on the tiles. I don't think there would be a issue. Never had problems with sps encrusting on plugs. Though I'm putting my dw acros on tile and I found the dw have never been good at encrusting.

I'm excited and nervous. Lol

Proteus · #7 04-21-2013, 02:24 PM

Got my pump yesterday. I picked up a speedwave 1320 gph. I finished the plumbing but was disappointed as I wanted to put in a small manifold to run reactors but didn't have the room. I guess I'll have to run a small maxi jet for reactors.

So tank got wet now that I can do leak test. Right away I had two leaks in the directional bulkheads. When I too them apart I noticed that the rubbers are half the size of a regular bulkhead. So I siliconed the rubbers in place and made sure the bulk heads are centered. If they fail again I will go with standard bulkhead with loc line attached.